UltraLED MTB 2000 cykellygte komplet sæt pandelampe med 2000 lumen

UltraLED MTB 2000 bicycle light complete set with battery – gives very good light

The UltraLED MTB 2000 bicycle light complete set is our smallest light in the UltraLED series, it weighs only approx. 77 g, but in relation to its size it provides a fantastic light! The light has been upgraded with more powerful LED L2, which means it will shine even more powerfully. This is a super MTB light that makes your trip in the woods late afternoon or evening on your mountain bike a great experience with lots of light.

Read the comprehensive test at cykelstart.dk – the test was made on our MTB 2000 light, but it is the same light, only the on/off button has been moved to the back of the light:  read here   and watch the video  here

The light is particularly suitable for forehead/helmet mounting due to its size. Ultra LED MTB 2000 is the perfect headlamp in combination with a more powerful MTB light on your bike, for example  UltraLed MTB 6000 , UltraLed MTB 8000 , UltraLed MTB 10,000 or UltraLed MTB 12,000 .

The dark forest becomes fully illuminated so you can drive fast. The battery pack, which connects to the light, can be attached to the frame (probably requires an extension cord), placed in the pocket or backpack.

MTB 2000 is the ultimate mountain bike light

and has 4 different brightness setting options that you can control yourself, whether you want full pressure on the light or whether you want a less powerful light.
The light and battery are 100% waterproof in the rain, so you don’t have to worry about the weather when using the 2000 bike light.
The light comes with a good battery – Li-ion Battery Pack – 8.4V/8,800 mAh Waterproof
EXTRA BATTERY TIME: We recommend buying an extra  UltraLed Platinum battery 8.4V 10,400 mAh – one so you are sure you have enough power for the trip.

The Mountain Bike UltraLed MTB 2000 set contains the following:

Bicycle headlight with 2 LED L2
Li-ion Battery pack – 8.4V/8,800 mAh Waterproof
Adjustable forehead bracket
Handlebar bracket
Battery charger 230v with charge indicator
2 pcs. O-rings for attachment

Note! – Instructions for battery use 
Charger lights up red when charging the battery and green when the battery is fully charged.
It is recommended to charge the battery to 100% first charge before use.
Never discharge the battery completely to 0% before recharging.
Always disconnect the battery from the light when not in use and avoid slow discharge to 0%
Never charge the battery at temperatures below 0 degrees Celsius

Read the comprehensive test at cykelstart.dk – the test was made on our MTB 2000 light, but it is the same light, only the on/off button has been moved to the back of the light:  read here   and watch the video  here

ATTENTION!
The light complies with min. requirements in the executive order on the design of bicycles, which is why the light must be used in places where the traffic law applies.

Usage time: usage time of up to 5 hours v. flashing strobe light
( Usage time is the number of hours the light can light up, where it complies with the Danish Transport Agency’s order no. 114 regarding brightness. After the end of the usage time, the light should be recharged to achieve full brightness again) 
Legal requirements for bicycle lights which is used in areas covered by the Road Traffic Act.
A bicycle light must be clearly visible at a distance of at least 300 meters without being dazzling. The 300 meter rule is, however, a rule of thumb – if it e.g. is foggy, of course the light cannot be seen at a distance of 300 metres. The light must also be visible from the side.
A headlight may light up yellow, white or bluish. If it lights up yellow, it must not flash. If it lights up white or blue, it is allowed to flash. If the light flashes, it must do so at a rate of at least 120 flashes per minute.
The rear light must light up red. A rear light may also flash. In that case, it must be done with at least 120 flashes per minute. Both the front and rear lights must be able to light up for min. 5 hours with sufficient brightness.